Temperature Control of Focused Beam Lamp: PID-Controlled Pulse Width Modulation using MATLAB Simulink and Arduino

Authors

  • Farid Baskoro State University of Surabaya
  • Miftahur Rohman State University of Surabaya
  • Dimas Arya S.F Aviation Polytechnic of Surabaya
  • Aristyawan Putra State University of Surabaya

DOI:

https://doi.org/10.30736/je-unisla.v9i2.1223

Abstract

This research explores the application of PID control on Arduino Uno using MATLAB Simulink to maintain temperature stability in a system. The main advantage of the PID approach is its adaptability to a variety of temperature control scenarios. Through MATLAB Simulink, users can easily optimize PID parameters such as P, I, and D according to system characteristics and specific needs. The three graphs analyzed depict the system response to changes in PID parameters. The first graph shows a moderate response with controlled fluctuations, reaching setpoint at 60 seconds. The second graph shows a dynamic and complex response, while the third graph produces a very active response with significant fluctuations. The results show that a higher P value results in a more active response and larger fluctuations, but the parameter adjustment must be carried out carefully to achieve a balance between fast response and system stability. In conclusion, the first graph strikes a good balance between responsiveness and stability, while the second and third graphs show the challenges in maintaining stability in certain situations

Downloads

Downloads

PlumX Metrics

Published

05-09-2024

How to Cite

Baskoro, F., Miftahur Rohman, Dimas Arya S.F, & Aristyawan Putra. (2024). Temperature Control of Focused Beam Lamp: PID-Controlled Pulse Width Modulation using MATLAB Simulink and Arduino. JE-Unisla, 9(2), 97–109. https://doi.org/10.30736/je-unisla.v9i2.1223

Issue

Section

editorial elektro