Desain Perbandingan MPPT P&O dan IC pada Solar Sel 1500 WP Menggunakan Konverter SEPIC

Authors

  • Luki Septya Mahendra Teknik Elektro Universitas Billfath Lamongan
  • Jauharotul Makmunah Teknik Elektro Universitas Billfath Lamongan
  • Karimatun Nisa Teknik Elektro Universitas Islam Lamongan

DOI:

https://doi.org/10.30736/je.v6i1.579

Keywords:

PV, MPPT P&O, MPPT IC, SEPIC Conveter

Abstract

Electricity is a very important requirement for life. The need for electrical energy has been dependent on fossil energy, while the availability of fossil energy is decreasing along with the increasing demand for electricity in the community, especially in Siman Village, Lamongan. To overcome this problem, many sources of energy substitutes for fossil energy have been developed and researched in the form of renewable energy sources, one of which is the source of solar energy. One of the applications of solar energy utilization is a solar cell. The proposed solar cell uses Photovoltaic (PV) 1500 WP as energy conversion. PV produces power that is volatile or erratic. So it requires Maximum Power Point Tracking (MPPT) so that PV works at its optimum point. MPPT can find the greatest power from PV using the Perturb and Observe (P&O) algorithm. The converter used is a SEPIC converter which functions to increase or decrease the voltage without changing the polarity of the resulting voltage. Furthermore, the MPPT P&O is compared the results with the MPPT Incremental Conductance (IC) as a comparison of the results of the average MPPT power.

 

 

Downloads

Download data is not yet available.

References

N. A. Windarko, A. Tjahjono, D. O. Anggriawan, and M. H. Purnomo, “Maximum Power Point Tracking of Photovoltaic System Using Adaptive Modified Firefly Algorithm,†pp. 31–35, 2015.

T. Latif and S. R. Hussain, “Design of a charge controller based on SEPIC and buck topology using modified Incremental Conductance MPPT,†in 8th International Conference on Electrical and Computer Engineering, 2014, pp. 824–827.

C. Series, “Performance comparison maximum power point tracking methods using SEPIC converter Performance comparison maximum power point tracking methods using SEPIC converter,†2020.

R. Ayop and C. W. Tan, “Design of boost converter based on maximum power point resistance for photovoltaic applications,†Sol. Energy, vol. 160, pp. 322–335, 2018.

B. Paranthagan, M. Marimuthu, and S. Shamili., “Comparative Analysis of Performance of the SEPIC Converter Using PID and Fuzzy Logic Controllers for LED Lighting Applications,†2015.

D. Haji and N. Genc, “Fuzzy and P O Based MPPT Controllers under Different Conditions,†in 2018 7th International Conference on Renewable Energy Research and Applications (ICRERA), 2018, pp. 649–655.

D. W. Hart, Power Electronics. McGraw-Hill, 2011.

S. I. Khather and M. A. Ibrahim, “Modeling and simulation of SEPIC controlled converter using PID controller Modeling and simulation of SEPIC controlled converter using PID controller,†no. February, pp. 833–843, 2020.

F. A. Harrag, S. A. Titraoui, and T. H. Bahri, “P O or IC for PV pumping system: What MPPT algorithm to improve performances?,†in 2017 6th International Conference on Systems and Control (ICSC), 2017, pp. 220–225.

Soedibyo, S. Anam, I. Hafidz, G. R. Zulkarnain, and M. Ashari, “MPPT design on solar farm using perturb and observe technique considering tilt angle and partial shading in Giligenting Island,†in 2017 International Seminar on Intelligent Technology and Its Applications (ISITIA), 2017, pp. 222–226.

I. Bouchriha, A. B. Ghanem, and K. Nouri, “MPPT Control of a Photovoltaic System based on Sliding Mode Control,†in 2019 International Conference on Advanced Systems and Emergent Technologies (IC_ASET), 2019, pp. 12–16.

L. S. M, I. Sudiharto, S. D. N, O. A. Qudsi, and E. Sunarno, “Design And Implementation Soft-switching MPPT SEPIC Converter Using P & O Algorithm,†vol. 01010, pp. 1–6, 2018.

Y. Wu, J. Li, and C. Li, “Study of the improved INC MPPT algorithm for PV systems,†in 2017 3rd IEEE International Conference on Control Science and Systems Engineering (ICCSSE), 2017, pp. 412–415.

K.S. Trey and S. Mekhilef, Solar Energy, 101, p. 335 (2014).

PlumX Metrics

Published

26-03-2021

How to Cite

Mahendra, L. S., Makmunah, J., & Nisa, K. (2021). Desain Perbandingan MPPT P&O dan IC pada Solar Sel 1500 WP Menggunakan Konverter SEPIC. JE-Unisla, 6(1), 434–442. https://doi.org/10.30736/je.v6i1.579

Issue

Section

editorial elektro