Prototype Pagar Otomatis Berbasis Arduino Uno Dengan Sensor Ultrasonic Hc-SR04
DOI:
https://doi.org/10.30736/je-unisla.v6i2.695Keywords:
Automatic Fence, Arduino Uno, HC-SR04Abstract
The process of opening and closing the fence manually is less effective, forexample, residents of the house have to go down and open the gate manually by pulling or pushing it by hand, whereas for certain conditions, such as when it
rains, opening and closing the fence manually will make it difficult. . The
purpose of this paper is to increase the efficiency and effectiveness of the gate
opening and closing process, where the process of opening and closing the fence can be done practically by using a DC motor connected to an Arduino Uno and an ultrasonic sensor HC-SR04. The process of opening and closing the door will be faster because the driver does not need to push open the fence or close the fence.
Downloads
References
Abdul Azis. Apriyadi, Nur Fajri. dan Usman., Rahmansyah (2017). Rancang Bangun Pagar Otomatis dengan Finger Print Berbasis Mikrokontroller. Jurnal Teknologi Terapan. Volume 3(1).38-39.
Lathif, Naslim. 2001. Aplikasi Sidik Jari Untuk Sistem Presensi Menggunakan Magic Secure 2500. (Makalah Seminar Tugas Akhir). Universitas Diponegoro. Semarang
Mujiman. 2008. Pintu Otomatis Berpengunci Waktu Berbasis Mikrokontroler AT89C51. (Jurnal Teknologi, Vol. 1, No. 1, 2008: 58 –67). Institut Sains dan Teknologi AKPRIND. Yogyakarta.
Oroh, Joyner R. 2014. Rancang Bangun Sistem Keamanan Motor Dengan Pengenalan Sidik Jari. (e-Journal Teknik Elektro dan
Komputer (2014), ISSN 23018402). Universitas Sam Ratulangi. Manado.
Sarwoko, Eko Adi. 2006. Mekanisme Sistem Identifikasi Biometrik. (Prosiding Seminar Nasional SPMIPA). Universitas Diponegoro. Semarang.
Anonim. 2013. Arduino Uno. Arduino. Milanhttp://arduino.cc/en/Main/arduinoBoar dUno. Anonim.2014. ATmega48A/PA/88A/PA/168A/PA/328/PDat asheetSumaryAtmel.California. www.atmel.com.DatasheetAVRAtmega328
Simbolon, Pahala Alpha Rinaldo. 2011. Aplikasi Sensor Ultrasonik Sebagai Pengendali Level Ketinggian Air Secara Otomatis Dengan Menggunaka Mikrokontroler ATmega 8535. (Tugas Akhir). Universitas Sumatera Utara. Medan.
Zuhal, 1988. Dasar Teknik Tenaga Listrik dan Elektronika Daya. Gramedia. Jakarta.
Sari, Ranti Permata. 2010. Penalaan Parameter Kontrol PID Dengan Metode Heuristic, Aplikasi: Sistem Pengendalian Kecepatan Motor DC. (Tugas Akhir). Institut Teknologi Sepuluh Nopember. Surabaya.
Sularso. 1978. Dasar Perencanaan dan Pemilihan Elemen Mesin. Pradnya Paramita. Jakarta.
Downloads
Published
How to Cite
Issue
Section
License
Jurnal JE-UNISLA : Electronic Control, Telecomunication, Computer Information and Power System is licensed under an Attribution-ShareAlike 4.0 International (CC BY-SA 4.0) license. You are free to:
Share — copy and redistribute the material in any medium or format
Adapt — remix, transform, and build upon the material for any purpose, even commercially. This license is acceptable for Free Cultural Works.
The licensor cannot revoke these freedoms as long as you follow the license terms.
Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
ShareAlike — If you remix, transform, or build upon the material, you must distribute your contributions under the same license as the original.
No additional restrictions — You may not apply legal terms or technological measures that legally restrict others from doing anything the license permits.
Copyright
Authors who publish with this journal agree to the following terms:
Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under an Attribution-ShareAlike 4.0 International (CC BY-SA 4.0) that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.
Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
Creative Commons License
Jurnal JE-UNISLA : Electronic Control, Telecomunication, Computer Information and Power System by Universitas Islam Lamongan is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Based on a work at https://jurnalteknik.unisla.ac.id/index.php/CVL/index
