JOBMIX BETON MENGUNAKAN PASIR LUMAJANG DAN PENAMBAHAN ADDITIVE MASTERPOZZOLITH®402R

Ahmad Ridwan, Annisa Chandra

Sari


Concrete is an important element in a construction. The strength of the concrete is determined by the quality of the concrete. So that the mixture used must meet the standards, by using selected materials and adding other substances, it will produce a higher quality than SNI. Masterpozzolith® 402R additive is a mixture of concrete material that serves as a bonding enhancer on concrete, this material will react with cement and water so that when the element is fused it will produce a better bond between coarse and fine aggregates. In this study concrete will use lumajang sand and add the masterpozzolith® 402R additive as an additional material to achieve the desired high quality. with a concrete job mix using the K-200, it is expected to produce concrete with a quality above the specified target. The results of this study can include more than the targets that have been determined, with planning to use mutubeton K-200 the concrete produced can reach K-222, so the method is quite good when applied in construction.


Kata Kunci


concrete, additive, masterpozzolith® 402R

Teks Lengkap:

PDF

Referensi


Istimawan Dipohusodo, 1994, STRUKTUR BETON BERTULANG, Gramedia PustakaUmum, Jakarta.

KardiyonoTjokrodimuljo, 1992, TEKNOLOGI BETON, Jurusan Teknik Sipil, FakultasTeknik, UGM, Yogyakarta.

Badan Standardisasi Nasional. 2000. Tata Cara Pembuatan Rencana Campuran Untuk Beton Normal. SNI 03-2834-2000

Tjokrodimulyo, Kardiyono. 1995. Teknologi Beton. Buku Ajar Jurusan Teknik Sipil Fakultas Teknik Universitas UGM. Yogyakarta.

Badan Standardisasi Nasional. 2008. Cara Uji Keausan Dengan Mesin Abrasi Los Angeles. SNI 2417-2008.

Badan Standardisasi Nasional. 2008. Cara Uji Slump Beton SNI 2417-2008

Peraturan Beton Indonesia (PBI 1971) .Peraturan Beton Bertulang Indonesia, Jakarta: Badan penyelidik Masalah Bangunan.

Badan Standardisasi Nasional. 1990. Metode Pengujian Kuat Tekan Beton SNI 03- 1974- 1990

Badan Standardisasi Nasional. 2008. Cara Uji Berat Jenis Dan Penyerapan Air Agregat Halus. SNI 1970-2008

Badan Standardisasi Nasional. 1990. Metode Pengujian Tentang Analisa Saringan Agregat Halus Dan Kasar. SNI 03- 1969- 1990.

Badan Standardisasi Nasional. 2011. Cara Uji Kuat Tekan Beton Dengan Benda Uji Silinder. SNI 1974- 2011.

Badan Standardisasi Nasional. 2011. Tata Cara Pembuatan Dan Perawatan Benda Uji Beton Di Laboratorium. SNI 2493- 2011.

https://assets.master-builders-solutions.basf. com/Shared%20Documents/PDF/English%20(Indonesia)/basf_MasterPozzolith %20402R_tds.pdf




DOI: https://doi.org/10.30736/cvl.v3i2.263

Refbacks

  • Saat ini tidak ada refbacks.


##submission.copyrightStatement##