Analysis Of Work Accident Risks in The Construction Of Sutet Steel Towers Using the JSA (Job Safety Analysis) Method
DOI:
https://doi.org/10.30736/cvl.v10i2.1455Keywords:
Job Safety Analysis (JSA), Occupational Health and Safety (OHS), Work Risk, Construction ProjectsAbstract
Construction activities inherently carry risks that can lead to accidents, causing delays, injuries, and financial losses. In high-risk projects such as High Voltage Direct Current (HVDC) transmission tower construction, inadequate safety practices and low awareness of Occupational Health and Safety (OHS) increase the potential for workplace accidents. This qualitative descriptive study analyzes potential work hazards in HVDC tower construction using secondary data and the Job Safety Analysis (JSA) method. Four main work processes—tower leg, body, and cross arm installation, and cable pulling—were assessed. Results show that all activities involve significant risks, with falls from height, falling objects, and puncture/scratch injuries being the most common. There are 6 activities in the Extreme category, 3 activities in the High category, 14 activities in the Moderate category, and 8 activities in the Low category. The main risks are falling from heights, being struck by materials, and injuries caused by work tools, which are exacerbated by low use of PPE, weak supervision, and lack of worker compliance. The solution to this problem lies in control priority, where there are four solutions: elimination, engineering, administration, and personal protective equipment control.
Downloads
References
S. A. Kuncaravita, R. A. Apriliani, M. Lawdy D.V, and D. Indri Y, “Analysis of Potential Hazards and Risks of Work Accidents by Using the HIRARC Method On Earthwork and Geosynthetics,” Civilla J. Tek. Sipil Univ. Islam Lamongan, vol. 10, no. 1, pp. 59–68, 2025, doi: 10.30736/cvl.v10i1.1350.
S. Susanto, D. A. Karisma, K. C. Budi, Sumargono, and B. Winarno, “Faktor yang Berhubungan dengan Pengetahuan Penerapan Keselamatan Kerja pada Pekerja Konstruksi,” J. CIVILLa, vol. 5, no. 2, pp. 476–485, 2020.
T. Y. Prastowo, Rahmadika Luthfi Manaf Imsarif, Dedy Sanjaya, and Nana Taryana, “Risk Analysis of Occupational Safety and Health (K3) Using the HIRADC Method on Chiller Replacement Works: A Case Study,” Civilla J. Tek. Sipil Univ. Islam Lamongan, vol. 9, no. 2, pp. 171–178, 2024, doi: 10.30736/cvl.v9i2.1266.
A. Arifuddin, M. N. Abduh, and Hijriah, “Analisis Risiko Kecelakaan Kerja Pada Pembangunan Konstruksi Tower Besi Baja SUTET,” J. Penelit. Tek. Sipil Konsolidasi, vol. 1, no. 1, pp. 17–23, Jan. 2023, doi: 10.56326/jptsk.v1i1.1548.
A. Z. Abidin and N. A. Mahbubah, “Pemetaan Risiko Pekerja Konstruksi Berbasis Metode Job Safety Analysis Di PT BBB,” J. Serambi Eng., vol. 6, no. 3, pp. 2111–2119, 2021, doi: 10.32672/jse.v6i3.3124.
ILO, Safety and Health at the Heart of the Future of Work : Building on 100 Years of Eexperience, no. April. 2019. [Online]. Available: https://www.ilo.org/safework/events/safeday/WCMS_686645/lang--en/index.htm
N. S. br Ginting and R. Kristiana, “Analisis Efektivitas Pengendalian Risiko Kecelakaan Kerja Pada Pekerja Proyek Konstruksi Menggunakan Metode Fine dan Fault Tree Analysis,” Teknik, vol. 41, no. 2, pp. 192–200, 2020, doi: 10.14710/teknik.v39i3.20265.
A. Suraji, “Studi Penerapan Kebijakan Keselamatan Pada Proyek Gedung di Indonesia,” J. Rekayasa Sipil, vol. 18, no. 3, p. 230, 2022, doi: 10.25077/jrs.18.3.230-243.2022.
F. Arif and A. Fauzi, “Analisis Identifikasi Proses Job Safety Analysis Pekerja Pada Ketinggian Dengan Metode Rope Access Pada PT. ISS Indonesia-Tangerang Selatan,” J. Disrupsi Bisnis, vol. 7, no. 1, pp. 18–23, 2024, doi: 10.32493/drb.v7i1.33417.
I. L. Kusminah, H. Natsir A, D. Wardani, and T. Dayanti, “Analisis Kekuatan Tekan dan Ketahanan Kejut pada Material Safety Helmet SNI dan Non SNI,” J. Elektro dan Mesin Terap., vol. 9, no. 2, pp. 298–305, 2023, doi: 10.35143/elementer.v9i2.5911.
I. Siboro, R. Hidayat, K. Rusba, U. Balikpapan, I. Bahaya, and P. Risiko, “Identifikasi bahaya dan penilaian risiko bekerja di ketinggian pada pt xyz balikpapan,” vol. 11, no. 2, pp. 381–387, 2025.
Yoto, D. Kustono, Marsono, and A. Qolik, “Pelatihan Manajemen Keselamatan dan Kesehatan Kerja Untuk Meningkatkan Keterampilan Bagi Tenaga Kerja Bidang Pengelasan Di Kota Malang,” J. Pengabdi. Pendidik. dan Teknol., vol. 1, no. 1989, pp. 90–102, 2020.
Rahmatullah, Andri, K. Umurani, H. S. Fathimah, and M. Hafiz, “Jurnal Talenta Sipil,” J. Talent. Sipil, vol. 8, no. 2, pp. 638–647, 2025, doi: 10.33087/talentasipil.v8i2.915.
M. A. Sasmitha, A. Andriyani, and T. Srisantyorini, “Pelatihan dan Pengawasan sebagai Upaya Meningkatkan Kepatuhan Penggunaan Alat Pelindung Diri (APD) untuk Menurunkan Tingkat Kecelakaan Kerja,” Bul. Kesehat. Mhs., vol. 3, no. 3, pp. 157–171, 2025, doi: 10.51888/jpmeo.v3i3.325.
Ramsen Cahyatri Fatmasari, Dito Adi Saputra, Frysilia Tri Oktiasari, and Indra Wijaya, “Perancangan Helm Safety di Proyek Tol Jogja Solo dengan Metode Job Safety Analysis (JSA),” Pop. J. Penelit. Mhs., vol. 4, no. 1, pp. 54–66, 2025, doi: 10.58192/populer.v4i1.2950.
M. N. Ikhsan, “Identifikasi dan Pengendalian Risiko Pada Pekerjaan Lifting Manual Menggunakan Metode Hazard Identification, Risk Assessment, and Risk Control (HIRARC),” J. Ind. Eng. Technol., vol. 1, no. 1, pp. 1–8, 2025, doi: 10.36277/jietech.v1i1.24.
Fitri, “Analisis Risiko Keselamatan Kerja Pada Pekerjaan Scaffolding,” J. Tek. Ibnu Sina, vol. 5, no. 1, pp. 1–11, 2020, doi: 10.3652/jt-ibsi.v5i01.100.
N. Raichaanah and N. Susanto, “Analisis Beban Kerja Manual Handling Pekerjaan Pengangkatan Kayu dengan Metode NIOSH dan Cardiovascular Load (CVL),” Ind. Eng. Online J., vol. 13, no. 1, 2024.
S. A. Lubis, B. Pasaribu, M. Husni, and M. Hasibuan, “Analisis Keselamatan Penggunaan Scaffolding pada Proyek Bangunan Bertingkat,” J. Multidisiplin Indones., vol. 3, no. 2, pp. 1500–1509, 2024.
A. Sa’Roni, “Penerapan Pertolongan Pertama pada Kecelakaan di Tempat Kerja,” Higeia J. Public Heal. Res. Dev., vol. 1, no. 3, pp. 247–261, 2020, [Online]. Available: https://journal.unnes.ac.id/sju/index.php/higeia/article/view/39412
R. Gultom, “Indonesia 1990,” Southeast Asian Aff. 1991, vol. 3, no. 1, pp. 107–121, 2018, doi: 10.1355/9789812306814-009.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2025 Rezi Berliana Yasinta, Muhammad Rasyid Fadhilah; Syakiila Az Zahra Al Buchori; Nadilla Hikmatul Hasanah; Fajar Hermawan
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Authors who publish in this journal agree to the following terms:
-
- Copyright on any article is held by the author.
- The author grants the journal first publication rights with the work licensed concurrently under a Creative Commons Attribution License that allows others to share the work with an acknowledgment of authorship and initial publication of the work in this journal.
- Authors may make separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of that journal (for example, posting it to an institutional repository or publishing it in a book), with an acknowledgment of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (for example, in an institutional repository or on their website) before and during the submission process, as doing so can lead to productive exchange, as well as earlier and greater citation of the published work.
- Published articles and related materials distributed under a Creative Commons Attribution-ShareAlike 4.0 International License
Civilla (Jurnal Teknik Sipil Universitas Islam Lamongan) by Universitas Islam Lamongan is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Based on a work at https://jurnalteknik.unisla.ac.id/index.php/CVL/index
