PENGARUH AIR PDAM, LAUT, COMBERAN PADA PROSES CURING TERHADAP KUAT TEKAN BETON Fc 14,53 Mpa

Authors

  • Richo Dwi Saputra Tekniki Sipil
  • Rasio Hepiyanto Teknik Sipil

DOI:

https://doi.org/10.30736/cvl.v2i2.78

Keywords:

Keywords, PDAM Water, Seawater, sewage, Curing, Concrete, Compressive Strength.

Abstract

Concrete is a mixture of concrete forming materials, namely: fine aggregate, coarse aggregate, cement, and water. Each concrete construction always be able to show its function, ie strength and endurance during the planned life. Therefore, in this research concrete treatment is known to increase the concrete but also need to know how long the concrete treatment is good Only requires water from the loss of water experienced. Thus the research is conducted to find out how much the influence of curing process uses sea water, PDAM sewage toward to the strength of concrete press. This research was conducted with the use of 3 types of water that is water PDAM, sea water, sewage. Cylindrical tests specimen with diameter 15 cm and height 30 cm. Each sample is made of 3 specimens by the age of 7 days. The value of compressive strength in PDAM water, seawater, sewage successively at the age of 7 days is 13,522 MPa, 8,759 MPa, 10,296 MPa. The value of compressive strength of Water PDAM at 7 days has increased compared to the compressive strength value of seawater and sewage, while the value of compressive strength of seawater has decreased compared to the rising sewage. So it can be concluded that the value of the highest compressive strength is water PDAM at the age of 7 days.

Downloads

Download data is not yet available.

Author Biographies

Richo Dwi Saputra, Tekniki Sipil

Mahasiswa Teknik Sipil

Rasio Hepiyanto, Teknik Sipil

Dosen Teknik Sipil Universitas Islam Lamongan

References

Danang Anwar Fauzi, 2013, Analisa Kuat Tekan Dan Kuat Tarik Beton Dengan Perawatan Dalam Lumpur Dan Air Laut, Naskah Publikasi, Universitas Muhammadiyah Surakarta.

Norman Ray, 2016, Studi Angka Koefisien Korelasi Kuat Tekan Beton Mutu Tinggi Berdasarkan Umur dan Bentuk Benda Uji Standart SNI 03-2844-2002, Jurnal Teknik Sipil, Universitas Widya Kartika Surabaya.

Ristinah Syamsuddin, 2011, Pengaruh Air Laut Pada Perawatan (Curing) Beton Terhadap Kuat Tekan Dan Absorspi Beton Dengan Variasi Faktor Air Semen Dan Durasi Perawatan, Jurnal Rekayasa Sipil Volume 5 No. 2, Universitas Brawijaya Malang.

Rosie Arizki Intan Sari, 2015, Pengaruh Jumlah Semen dan Fas Terhadap Kuat Tekan Beton Dengan Agregat Yang Berasal Dari Sungai, Jurnal Sipil Stastik Vol.3 No.1, Manado.

SNI-7394-2008, Tata Cara Perhitungan Harga Satuan Pekerjaan Beton untuk Kontruksi Bangunan Gedung dan Perumahan.

Ir. Erry Irianto, 1988, Insitut Sains dan Teknologi Nasional Fakultas Teknik Sipil dan Perencanaan Laboratorium Beton, Pedoman Praktikum Beton, Jakarta Selatan.

PlumX Metrics

Published

2017-11-15

How to Cite

Saputra, R. D., & Hepiyanto, R. (2017). PENGARUH AIR PDAM, LAUT, COMBERAN PADA PROSES CURING TERHADAP KUAT TEKAN BETON Fc 14,53 Mpa. Civilla : Jurnal Teknik Sipil Universitas Islam Lamongan, 2(2), 6 Halaman. https://doi.org/10.30736/cvl.v2i2.78

Issue

Section

Jurnal CIVILA