Optimasi Kinerja Sensor Value untuk Meminimalisir Kelembapan Udara Sebagai Pengganti Sinar Matahari

Authors

  • Sugiono sugiono Teknik Elektro Universitas Islam Malang
  • Unung Lesmanah Teknik Mesin Universitas Islam Malang
  • Arief Budi Laksono Teknik Elektro Universitas Islam Lamongan

DOI:

https://doi.org/10.30736/je.v6i1.580

Keywords:

optimization, sensor value work, air flow, sunlight, pipes

Abstract

Optimization of sensor value work on air humidity to generate renewable energy so that a Sensor Value is needed as a substitute for sunlight in the rainy season. In previous studies, there are several problems such as low sunlight in the resulting rainy season and the operation requires a long time, so one solution to overcome the above problems requires a Value sensor at a temperature of 800 C. In this research, there are two main objectives, namely increasing the efficiency of the system and simplifying the operation method. Increasing efficiency is done with several alternatives, namely minimizing the humidity of the surrounding air so that it can improve the sensor's work, while simplifying the operation is done by adding a value sensor module to adjust the heat focus. In the first stage of mechanization of value rays in the piping system, the second is testing of the sensor to the humidity of the surrounding air. This research will focus on the function of each component such as the heating room temperature sensor, while the main target is to generate heat in the rainy season

Downloads

Download data is not yet available.

References

Akira Nishimura1*, Takuya Ito1, Junsuke Murata1, Toshitake Ando1, Yasunari Kamada1, Masafumi Hirota1, Mohan Kolhe2,†Wind Turbine Power Output Assessment in Built Environmentâ€, 1Division of Mechanical Engineering, Graduate School of Engineering, Mie University, Tsu, Japan; 2School of Energy & Resources, University of College London, Adelaide, Australia, October 3rd, 2012

Deshpande, MV.,â€Electrical Power Sistem Designâ€, New Delhi : Tata McGraw – Hill, 1990

Ismail T, Anton K, 2011. Rancang Bangun Alat Pengering Ubi Kayu Tipe Rak Dengan Memanfaatkan Energi Surya. Prosiding Seminar Nasional AvoER ke-3, 26-27 Oktober 2011. Palembang.

Deshpande, MV.,â€Electrical Power Sistem Designâ€, New Delhi : Tata McGraw – Hill, 1990

Jensen, S.O., 2002. Solar drying in Ghana – Final report. Solar Energy Centre Denmark, Danish Technological Institute. ISBN 87- 7756-659-9.

Firmasnyah B, A Firdaus, 2011. Kaji Eksperimental Alat Pengering Kerupuk Tenaga Surya Tipe Box Menggunakan Konsentrator Cermin Datar. Prosiding Seminar Nasional AVoER ke-3, 26 s-d 27 Oktober 2011. Palembang.

Budiman Sudia, 2010. Unjuk Kerja Kolektor Surya Plat Datar Menggunakan Konsentrator Dua Cermin Datar. Dinamika, ISSN:2085- 8817 hal.85-90.

Phillips, Charles L & Nagle, H. Troy, “ Digital Control System Analysis & Design, ed. 3, Prentice Hall, 1995.

PlumX Metrics

Published

26-03-2021

How to Cite

sugiono, S., Lesmanah, U., & Laksono, A. B. (2021). Optimasi Kinerja Sensor Value untuk Meminimalisir Kelembapan Udara Sebagai Pengganti Sinar Matahari. JE-Unisla, 6(1), 448–452. https://doi.org/10.30736/je.v6i1.580

Issue

Section

editorial elektro