Analysis of the Precast Half Slab Method in Batang I Industrial Workers Flats Development Project
DOI:
https://doi.org/10.30736/cvl.v8i1.1003Keywords:
half slab, conventional, cost, timeAbstract
This study aims to analyze the application of Precast Half Slab formwork with conventional formwork in terms of cost, time, and implementation stages. The method used in this study is the precast half slab method. The Batang I Industrial Worker Flats project is in the Batang Integrated Industrial Estate. In the highly advanced construction era, many projects compete to innovate to produce a fast and efficient building. This Project uses the precast half slab method, where half of the floor slab is printed offsite (precast) with a thickness of 7 cm, and the other half is in place (topping 5.5 cm). This final Project analyzes the precast half slab method used by comparing it to the conventional method in terms of cost and time, so it can be seen which method is more profitable. The precast half-slab method analysis focuses on calculating the direct cost of conventional half-slab precast in terms of materials, tools, and worker wages, as well as calculating the time needed for each job.
Downloads
References
T. H. Wijaksono, O., Tistogondo, J., & Bagio, “Analisis Perbandingan Efisiensi Waktu Dan Biaya Antara Metode Konvensional Slab, Precast Half Slab Dan Precast Full Slab Pada Proyek Bangunan Hotel Bertingkat Di Surabaya.,†Pros. Semnastek., 2018.
PT Pembangunan Perumahan (Persero) Tbk., “Work Methode Statement Proyek Rumah Susun Pekerja Industri Batang I,†2022.
V. Aprilia, “Analisis Perbandingan Sistem Struktur Pelat Konvensional Dan Half Slab Ditinjau Dari Segi Biaya Dan Waktu,†2021.
D. Aprisandi, “Analisis Biaya Dan Waktu Metode Half Slab Dalam Pembangunan Proyek Konstruksi.,†J. Lingkung. Dan Sumberd. Alam (JURNALIS), 1(1), 51-61., 2018.
R. Rahman, “Analisis Perbandingan Biaya Pelat Lantai Antara Metode Precast Half Slab Dan Metode Konvensional (Cost Comparison Analysis Between Precast Half Slab Method And Conventional Method)(Studi Kasus: Proyek Pembangunan Pasar Prambanan).,†2019.
PT Pembangunan Perumahan (Persero) Tbk., “Precast Half Slab. Jakarta,â€
D. H. Wisanggeni, “Perbandingan Sistem Pelat Konvensional dan Precast Half Slab Ditinjau Dari Segi Waktu dan Biaya Pada Proyek My Tower Apartement Surabaya,†2017.
S. Edhi, “Analisa Perbandingan Waktu Dan Biaya Metode Konvensional Dengan Flat Slab Struktur Pelat Lantai Apartemen Grand Dharmahusada Lagoon Surabaya.,†2019.
S. Dewi, I. A., & Sukobar, “Perhitungan Waktu dan Biaya Pelaksanaan Proyek Pembangunan Apartemen Solo Urbana Residence Tower D dengan Metode Half Slab.,†J. Tek. ITS, 11(2), C35-C41., 2022.
N. K. Saragi, T. E., & Zalukhu, “Analisa Perbandingan Pelaksanaan Struktur Pelat Lantai Metode Konvensional, Boundeck Dan Precast Full Slab Ditinjau Dari Segi Waktu Dan Biaya Pada Proyek Pembangunan Gedung Gbkp Tanah Merah Binjai.,†J. Constr. 1(2), 38-52., 2022.
U. Suaiba, “Analisa Perbandingan Sistem Half Slab Dan Plat Konvensional Ditinjau Dari Segi Waktu Dan Biaya Pada Proyek Apartemen Gunawangsa Tidar Surabaya.,†Elem. J. Tek. Sipil, 1(1), 1-9., 2019.
M. A. Trijeti, Farid Dwi Atmawan, “Time And Cost Comparison Of Conventional And Alternative Plate Hollow Slab, Halfslab And Metaldeck,†Int. J. Sci. Technol. Res. Vol. 7, ISSUE 06, 2018.
A. Juara, “Jadi Pengaruh Kuat Tekan Beton Dengan Limbah Biji Salak Kering Sebagai Pengganti Sebagian Agregat Kasar.,†Teras, 12(1), 19-28., 2022.
F. Rochman, T., Rasidi, N., & Purnomo, “The Flexural Performance Of Lightweight Foamed Precast Concrete Slabs: Experimental And Analysis.,†Geomate Journal, 20(77), 24-32., 2021.
N. Oktavianto, D., & Rochmah, “Perencanaan Struktur Gedung Kantor Otoritas Jasa Keuangan (Ojk) Kawasan Regional 4 Dengan Metode Beton Pracetak.,†Padur. J. Tek. Sipil Univ. Warmadewa, 11(2), 229-239., 2022.
I. Rakhmawati, A. N., Devia, Y. P., & Wijatmiko, “Life Cycle Assessment (LCA) Analysis Of Concrete Slab Construction For Estimating The Environmental Impact.,†Rekayasa Sipil, 14(3), 232-237, 2020.
M. Kurniawan, “Perbandingan Analisis Struktur dan Efisiensi Biaya Struktur Slab on Pile Menggunakan Metode Precast Half-Slab dan Metode Monolite, Serta Kombinasi Mutu Beton Slab on Pile (Studi Kasus Jembatan Perawang). Jurnal Saintis, 16(1), 46-62.),†2016.
M. ARI N U G RAH A N U RJA MAN, Basic Precast System And Precast Outlook In Seismic Region Of Indonesia. 2018.
W. (2022). Riyadi, I., Handayani, E., & Dony, “Analisa Perbandingan Sistem Pelat Konvensional dengan Sistem Precast Half Slab dalam Segi Waktu dan Biaya.,†J. Civronlit Unbari, 7(2), 63-69., 2019.
Badan Standarisasi Nasional., Persyaratan Beton Struktural untuk Bangunan Gedung (SNI-2847-2019).Jakarta. 2019.
Downloads
Additional Files
Published
How to Cite
Issue
Section
License
Authors who publish in this journal agree to the following terms:
-
- Copyright on any article is held by the author.
- The author grants the journal first publication rights with the work licensed concurrently under a Creative Commons Attribution License that allows others to share the work with an acknowledgment of authorship and initial publication of the work in this journal.
- Authors may make separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of that journal (for example, posting it to an institutional repository or publishing it in a book), with an acknowledgment of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (for example, in an institutional repository or on their website) before and during the submission process, as doing so can lead to productive exchange, as well as earlier and greater citation of the published work. .
- Published articles and related materials distributed under a Creative Commons Attribution-ShareAlike 4.0 International License
Civilla (Jurnal Teknik Sipil Universitas Islam Lamongan) by Universitas Islam Lamongan is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Based on a work at https://jurnalteknik.unisla.ac.id/index.php/CVL/index
